Description
- Adjust by sliding the micro-cord Prusik up or down the length of the bungee cord
- Safety-stopper knot prevents Prusik from sliding off the end
- No coils to stretch out or get reverse-twisted
- Designed to be used for small gear without any attachment hardware, but aluminum wire-gate carabiners are included for applications where quick or frequent attachments/detachments are required (Typically, only one carabiner is required for most quick-attach/detach applications)
- To attach, slip the micro-cord loop through a tether attachment point on your gear and then pull the entire tether back through the loop.
- Once Better Tether is attached to the device, insert the large bungee loop through/around the object to which you wish to attach the gear and pull the device back through the bungee loop (Bungee loop is designed to fit around most rangefinder-sized devices. If the device is too large to fit through the bungee loop, use one of the included wire-bail carabiners to secure the bungee loop to the object)
- Cut the bungee cord to any desired length (A replacement heat-shrink endcap to seal the end once cut is included)